Zebra-technologies ZebraNet ZM400TM User Manual download pdf (Page 112)

Hardware Troubleshooting

Troubleshooting the 10/100 PS

112

14197L-001 Rev. A ZebraNet

10/100 Internal Print Server for ZM400 and ZM600 User Guide 04/19/2007

Telnet

Open a telnet session to send a ZPL command from a DOS prompt. This procedure can be

used when running v53.15 or later firmware. In this example, a ZPL II command is used to

cause a label to print.

To open a telnet session on your PC, complete these steps:

1. Open a DOS window.

To open a DOS window, click on

Start > Run.

2. In the Open text box, type: cmd

3. From the DOS prompt, type:

telnet xxx.xxx.xxx.xxx 9100

where xxx.xxx.xxx.xxx is the IP address of the print server.

This will connect your PC to the 10/100 Internal PS through the parallel port of the printer.

4. Enter ~WC.

This ZPL command will print a configuration label on your printer.

5. Click the X in the upper right-hand corner of the window to exit.

If the configuration label prints, the issue is not a communication problem between the printer,

the print server, or the PC.

Unable to Configure Device

To assign an IP address to a ZebraNet 10/100 Internal PS using ZebraNet View, you must be

on the same subnet. If ZebraNet View has Multicast enabled, you may be able to view the

ZebraNet 10/100 Internal PS on another subnet, but you will not be able to configure the

device.

Note • You do not need to open a telnet session if you pinged the printer using the previous

procedure. The purpose of these two procedures is to identify whether your PC can

communicate with your printer.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 129 130

No comments

Zebra-technologies ZebraNet ZM400TM User Manual Page 112